Help guide for Yamaha eBikes from 2019 onwards
Once you have installed the device there are 2 stages to getting your device setup; stage 1 and stage 2. Both parts must be completed in order to program the VOLspeed correctly.
Before you begin the setup process, ensure your display is set to kmh. To do change from mph simply press and hold both up/down buttons for a few seconds until the display flashes, then use your up button to switch to khm.
Stage 1 - Initial setup
With your display on and in the ODO screen, cycle through the sequence below:
Following this combination you will see the following sequence
11.1kmh --> 22.0 --> 25.0kmh --> 0.0kmh
Do not press any buttons during at this stage
If your display does not follow this sequence check you have connected the device correctly.
Initial setup is complete
Stage 2 - Speed Mode
Once you have completed the initial setup it's time to set your new max assistance speed. Starting in setting high, complete the sequence below:
After this sequence you will see 32.0kmh appear on your display. In order to increase this number to your desired speed, simply click from STD -> HIGH -> STD -> HIGH
Repeat this combination until the number increases to the figure you would like
Please note, if you wish to reduce the number, simply click from STD -> ECO -> STD -> ECO
Once completed, your VOLspeed is successfully programmed.
Each time you turn your bike on, you will need to activate the VOLspeed by completing the sequence below;
If you do not wish to ride derestricted, just turn your bike on as normal and it will ride with its factory settings.
Comments
0 comments
Please sign in to leave a comment.